Cfgdisable – Dell POWEREDGE M1000E User Manual
Page 123
Fabric OS Command Reference
91
53-1001764-02
cfgDisable
2
cfgDisable
Disables a zone configuration.
Synopsis
cfgdisable
Description
Use this command to disable the current zone configuration. The fabric returns to non-zoning
mode, in which all devices see each other.
This command ends and commits the current zoning transaction buffer to both volatile and
nonvolatile memory. If a transaction is open on a different switch in the fabric when this command
is run, the transaction on the other switch is automatically aborted. A message displays on the
other switches to indicate that the transaction was aborted.
If the default zone access mode is “No Access”, then this command becomes cfgEnable
“d_efault_Cfg”. Refer to defZone help for zone access configuration.
Notes
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
When an FCS policy is enabled, this command can be issued only from the primary FCS switch.
Operands
none
Examples
To disable the current zone configuration:
switch:admin>
cfgdisable
You are about to disable zoning configuration. This
action will disable any previous zoning configuration enabled.
Do you want to disable zoning configuration? (yes, y, no, n): [no]
y
See Also
cfgClear, cfgEnable, cfgSave