Dell POWEREDGE M1000E - Manual (Page 411)

Fabric OS Command Reference 379
53-1001764-02
fwSetToCustom
2
fwSetToCustom
Sets Fabric Watch thresholds and alarm levels to custom values.
Synopsis fwsettocustom
Description Use this command to set threshold and alarm levels to custom values for all Fabric Watch classes
and areas.
Fabric Watch uses two types of settings: factory default settings and user-defined custom settings.
• Factory default settings are automatically enabled. These settings vary depending on hardware
platform, and cannot be modified.
• For some Fabric Watch parameters, you can create custom configurations to suit your unique
environment.
The fwSetToCustom command allows you to switch from default to custom settings. The command
assumes that a set of user-defined thresholds have been configured prior to executing the
fwSetToCustom command. If no user-defined settings exist, this command reapplies the default
values.
Use the advanced configuration option provided with the portThconfig, thConfig, and sysMontitor
commands to view and modify custom and default values for specified classes and areas in Fabric
Watch. For specific configuration procedures, refer to the Fabric Watch Administrator’s Guide.
Notes This command requires a Fabric Watch license.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands none
Examples To apply configured custom settings to all Fabric Watch classes and areas:
switch:admin>
fwsettocustom
Committing configuration...done.
To view the current Fabric Watch configuration for the environment class:
switch:admin> sysmonitor --show env
Class: ENV
Area : TEMP
ThLevel : Cust
ActLevel: Cust
High :
Custom:
TimeBase: None
Value : 90
Trigger : Above Action: Raslog,SNMP
Trigger : Below Action: None
Default:
TimeBase: None
Value : 65
Trigger : Above Action: Raslog,SNMP
Trigger : Below Action: Raslog,SNMP
Low:
Custom: