Dell POWEREDGE M1000E - Manual (Page 256)

224 Fabric OS Command Reference
53-1001764-02
errFilterSet
2
errFilterSet
Sets a filter for an error log destination.
Synopsis errfilterset [-d “destination"][-v severity]
Description Use this command to set a filter for an error log destination. A filter is set based on the severity level
of the messages.
If no parameters are specified, this command displays the filters that are currently in use.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
-d destination Specifies the destination for the filter. The string console is the only valid
value at this time.
-v severity Specifies the minimum severity level of the message to pass through the
filter. Valid values are INFO, WARNING, ERROR, or CRITICAL. Input values are
not case-sensitive.
Examples To display the current filter settings:
switch:admin>
errfilterset
console: filter severity = WARNING
To set the filter severity level for the console:
switch:admin>
errfilterset -d console -v warning
See Also errDump, errShow