Dell POWEREDGE M1000E - Manual (Page 448)

416 Fabric OS Command Reference
53-1001764-02
iodDelayShow
2
iodDelayShow
Displays the user-defined IOD delay settings for specified domains.
Synopsis ioddelayshow [ domain_id ]
Description Use this command to display the user-defined IOD delay settings for all domains in the fabric or for
a specified domain ID. This command only displays delay values for domain IDs, for which the IOD
delay parameter has been previously set with the iodDelaySet command. The command does not
display defaults values.
Note The iodDelaySet command is deprecated in Fabric OS v6.2.0. The iodDelayReset command is
retained for legacy reasons only. If you have configured IOD delay settings previously, you must
reset the IOD settings to defaults before upgrading to v6.2.0. Use iodDelayShow to determine
current settings.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A,
"Command Availability" for details.
Operands The following operand is optional:
domain_id Specifies the domain ID for which to display the IOD delay setting. If this
operand is omitted, the command displays the IOD delay settings for all
domains in the fabric.
Examples To Display the IOD delay setting for domain 5:
switch:user> ioddelayshow 5
Domain - Iod Delay
5 - 20
To display IOD settings for all domains in the fabric:
switch:user>
ioddelayshow 5
Domain - Iod Delay (ms)
1 - 2
5 - 20
10 - 20
20 - 30
21 - 23
See Also iodDelaySet