Cyclades PM IPDU - Manual (Page 26)

14 Cyclades PM IPDU Installer/Administrator/User Guide
See the following section for a list of power cables shipped with specific PM IPDU models.
Modular input power cables for the PM IPDU
If your PM IPDU model does not have a fixed power input cable, it may ship with one of the
modular cables listed in the following sections. Depending on your site’s location, the modular
input power cables included in the box vary. See the following sections to find the input cable that
should ship with your PM IPDU product:
• PM8i-10A IPDU and PM10i-10A IPDU power cables on page 15
• PM10i-15A IPDU power cables on page 16
• PM10i-16A IPDU and PM 20i-16A IPDU power cables on page 16
NOTE: The Cyclades PM 10i-32Au IPDU ships with an unterminated power cord. If necessary, your Cyclades
representative may provide guidelines on approved power plug installation.
CON0132 RJ-45 loopback connector In case the administrator forgets the admin's
password, this is used to place in the OUT port to gain
temporary access to the box using the factory default
password.
See To reset the admin password using the loopback
connector: on page 25.
210105 PM IPDU to DSR switch cable
adaptor Used to connect Cyclades PM IPDU to an Avocent
DSR switch.
HAR0220 2 mounting brackets with 8 screws
(2 spares). For PM10 IPDU and
PM10i IPDU Use to mount the Cyclades PM10 IPDU and PM10i
IPDU to a rack or wall. See To mount the Cyclades
PM8i IPDU, PM10 IPDU or PM10i IPDU: on page 18.
HAR0302 2 mounting brackets with 5 screws
(1 spare). For PM8i IPDU Use to mount the Cyclades PM8i IPDU to a rack or
wall. See To mount the Cyclades PM8i IPDU, PM10
IPDU or PM10i IPDU: on page 18.
Table 2.1: PM IPDU Shipping Box Contents, Part Numbers and Description (Continued)
P/N Description Purpose