Cyclades PM IPDU - Manual (Page 38)

26 Cyclades PM IPDU Installer/Administrator/User Guide
7. If you need to recover the password of many Cyclades PM IPDUs connected in a daisy chain,
go to step 1 and perform the procedure on each Cyclades PM IPDU in the chain.
Upgrading the Cyclades PM IPDU Firmware
Starting with version 1.1.0, the Cyclades PM IPDU firmware may be upgraded through its IN port.
The upgrade procedure described here is only valid for units that are currently running firmware
versions 1.3.0 or greater. If your Cyclades PM IPDU is running an older firmware version, please
follow the instructions in the manual that corresponds to the firmware currently installed on the PM
IPDU. Visit ftp://ftp.cyclades.com/pub/cyclades/alterpath/pm/doc/ for older versions of
this manual.
To upgrade PM IPDU firmware:
1. Download the new Cyclades PM IPDU firmware from the Cyclades web site.
After downloading the Cyclades PM IPDU firmware file, save it to the workstation connected
to the Cyclades PM IPDU console (IN port).
2. Using either Hyperterminal or Minicom, log into the Cyclades PM IPDU as admin and type in
the command:
If you are currently logged in as a different user, log out and then login as admin.
The <IPDU#> is the number of the IPDU to which you want to upgrade the firmware. If you have
only one Cyclades PM IPDU, type
upgrade 1 . If you have, for instance, three units in a daisy
chain, type upgrade 3 or upgrade 2 depending on which unit you want to upgrade.
NOTE: If you have a daisy chain and you want to upgrade all units, you should start from the last unit and work
your way towards the first.
pm>upgrade <IPDU#>