Cyclades PM IPDU - Manual (Page 49)

Chapter 4: Command Line Interface 37
Examples
To display current protection status for all units, enter the following.
To enable current protection status for all units, enter the following.
To disable current protection status for all units, enter the following.
currseg
The currseg command lets you view the current for the lower or upper segment of outlets. This
command is only useful for IPDUs with dual current sensors (30A and 32A models). The lower
segment (segment A) would be outlets 1-5 on a PM 10 series IPDU, and the upper segment
(segment B) would be outlets 6-10 on a PM 10 series IPDU.
Syntax
currseg A|B [reset]
Arguments
A|B segment A or segment B
reset Clears the max recorded current for A & B.
Example
To view the current load of segment A, enter the following.
pm> currentprotection status
IPDU #1: Overcurrent protection is OFF.
IPDU #2: Overcurrent protection is OFF.
pm>currentprotection ON
IPDU #1: Overcurrent protection turned ON.
IPDU #2: Overcurrent protection turned ON.
pm>currentprotection off
IPDU #1: Overcurrent protection turned OFF.
IPDU #2: Overcurrent protection turned OFF.
pm>currseg A
IPDU #1: True RMS current for segment A: 0.4A. Maximum current for
segment A: 0.
4A