Cyclades PM IPDU - Manual (Page 35)

23
Configuration
The Cyclades PM IPDU may be configured by any one of three methods:
• Command Prompt - Full configuration capabilities.
• Browser - Available only when the PM IPDU is connected directly to an AUX port on a KVM
switch or OnSite appliance or connected directly to a serial console port on an ACS console
server, TS terminal server or OnSite appliance. This menu allows you to invoke the various
PM IPDU operations, such as cycling, switching on, switching off and basic configurations of
the power management session to communicate with the PM IPDU. Only a limited number of
parameters may actually be changed and saved to the PM IPDU.
• Text-based menu - Available only when used in an integrated configuration. This menu allows
you to invoke the various PM IPDU operations such as cycling, switching on, switching off
and more.
The following sections offer basic instructions for configuring, restoring the admin password, and
uploading firmware on the Cyclades PM IPDU for either the standalone or the daisy
chained configuration.
For information about integrated use with the Cyclades ACS console server, Cyclades TS terminal
server, Cyclades KVM switch or the Cyclades OnSite appliance, refer to the documentation
relevant to each product family.
Default Configuration Parameters
The Cyclades PM IPDU’s default configuration is as follows:
• User is admin.
• admin user’s password is pm8.
• All outlets are un-named.
• All outlets are unassigned to user.
• All outlets are turned on.
• All outlets are unlocked.
C H A P T E R
3