Dynojet 224: Pit Eddy Current Brake - Manual (Page 14)

Model 224 Pit Eddy Current Brake Installation and User Guide
C H A P T E R 1
Eddy Current Brake Installation
1-10
4 Remove the two screws securing each pit cover support. Set the screws and
covers aside.
# RECORD
Be sure you record the dynamometer and/or eddy current brake number on
the inside cover of this manual.
Figure 1-4: Remove the Pit Cover Supports
I NSTALLING THE B EARING
The eddy current brake can be installed on either side of your dyno, the installation
instructions are the same.
1
Install the bearing using two 1/2-13 x 1.25-inch flanged bolts. Leave the bolts
loose.
Note: If you are retrofitting an early model dyno which does not have the bearing
mounting holes, refer to the instructions in Appendix C.
Figure 1-5: Install the Bearing
EB096
pit cover support
pit cover support
brake number
bearing
bearing mounting
holes