Connecting the secondary inductive pickup, Connecting the secondary inductive pickup -6 – Dynojet 224: Pit Eddy Current Brake User Manual

Page 48

Advertising
background image

Model 224 Pit Eddy Current Brake Installation and User Guide

C H A P T E R 3
Connecting The RPM Pickup

3-6

C

ONNECTING

THE

S

ECONDARY

I

NDUCTIVE

P

ICKUP

The secondary inductive pickup cannot be in contact with, or it’s connecting wire be
crossing, other engine electrical wires or stray RF interference may result.
1

Clip the secondary inductive pickup around one spark plug wire.

2

Route the inductive pickup cable clear of devices that produce electronic noise
(spark plug wires, coil wire, coil etc.).
Note: Inductive pickup placement is important. Position the inductive pickup so
that it is not making contact with any other spark plug wires. Separate the spark
plug wire from the spark plug wire bundle for proper operation.
Note: You must ground the vehicle to the dyno for the electronics to function
properly.

Figure 3-3: Secondary Inductive Pickup

Figure 3-4: Separate Spark Plug Wire

connect secondary

inductive pickup on a

single spark plug wire

automobile

distributor

Advertising