Dynojet 224: Pit Eddy Current Brake - Manual (Page 30)

Model 224 Pit Eddy Current Brake Installation and User Guide
C H A P T E R 2
Torque Module Installation
2-4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TORQUE MODULE INSTALLATION
This section describes how to access the dyno electronics, install the Torque Module,
route the load cell cable, and install the side and top brake covers.
A CCESSING THE D YNO E LECTRONICS
You will need to access your dyno electronics in order to add the torque module. Use
the following steps to access the dyno electronics.
1
Remove the eight screws securing the cover and lift the cover off.
2 Add the torque module to the top of the dyno electronics. Refer to “Installing the
Torque Module” on page 2-5.
3 Leave the dyno electronics enclosure out. You will need to route the load cell
cable to the Torque Module later.
Figure 2-3: Inside the Electronics Enclosure
dyno electronics