Testing for correct voltages – Dynojet 224: Pit Eddy Current Brake User Manual
Page 60
Advertising
Model 224 Pit Eddy Current Brake Installation and User Guide
A P P E N D I X B
Power Requirements and Installation
B-4
T
ESTING
FOR
C
ORRECT
V
OLTAGES
You must test the receptacle for proper voltages before the dyno is connected to the
outlet.
Using a voltmeter that is capable of measuring AC voltage, measure between the
points listed below and verify that the correct voltages are present.
Figure B-2: Testing the Wall Receptacle
probe 1
probe 2
desired voltage measurement
1
3
220V to 250V
2
box
<5V
1
2
3
Advertising