Dynojet 224: Pit Eddy Current Brake - Manual (Page 22)

Model 224 Pit Eddy Current Brake Installation and User Guide
C H A P T E R 1
Eddy Current Brake Installation
1-18
R OUTING THE B RAKE C ABLES
Refer to Figure 1-14 on page 1-18 for cable routing location information.
1
Route the temperature sensor cable from the eddy current brake over to the
Breakout board.
For more information on wiring the Breakout board refer to page 1-19.
2 Route the speed pick-up cable from the Breakout board over to the pick-up card.
3 Route the 25-pin cable from the Breakout board along the inside of the panel
using the cable routing channel, through one of the PVC conduits in the pit, and
to the dyno electronics.
4 Route the brake power cable from the eddy current brake through the pit cover
support and over to the Theta Controller (underneath).
5 Route the input power cable from the Theta Controller through pit cover
support, through the PVC conduit in the pit (not used by any other cables), and to
your power source.
6 Route the control cable from the Theta Controller to the Breakout board.
Figure 1-14: Routing the Brake Cables
control cable
temperature
sensor cable
brake power cable
input power cable theta controller
breakout board
speed pick-up
cable
25-pin cable