Dynojet 224: Pit Eddy Current Brake User Manual
Page 19
E D D Y C U R R E N T B R A K E I N S T A L L A T I O N
Eddy Current Brake Installation
Version 2
Model 224 Pit Eddy Current Brake Installation and User Guide
1-15
I
NSTALLING
THE
P
IT
C
OVER
S
UPPORTS
AND
T
HETA
C
ONTROLLER
1
Loosely secure the pit cover supports to the frame using two 1/4-20 x 3/4-inch
button-head flange screws for each support.
Note: Do not tighten the screws.
2
Verify the pit cover supports are flush with the top of the pit floor before you
tighten the screws.
2a
Place a straight edge across the pit cover supports.
2b
With the pit cover supports tight against the straight edge, tighten the
screws.
Note: You can use c-clamps to attach the upright to the straight edges to make
this quicker. Tighten the c-clamps until the pit cover supports are flush with the
pit floor.
2c
Remove the straight edge.
Figure 1-11: Install the Pit Cover Supports
pit cover
supports