Dynojet 224: Pit Eddy Current Brake User Manual
Page 65
Advertising
I N S T A L L I N G T H E A D A P T E R A N D B E A R I N G — E A R L Y M O D E L D Y N A M O M E T E R S
Installing the Adapter and Bearing—Early Model Dynos
Version 2
Model 224 Pit Eddy Current Brake Installation and User Guide
C-3
4
Using the template included in this appendix, drill four additional holes into the
dyno frame as shown.
Note: If you needed to use the adapter plate, you will need to drill brake
mounting holes in the dyno frame.
4a
Line the template up with the existing hole on the dyno.
4b
Drill two 3/8-16-inch UNC holes on each side of the dyno.
Figure C-3: Early Model Dynos—Using the Template
template
drill holes
existing hole
template
drill holes
existing hole
Advertising