Dynojet 224: Pit Eddy Current Brake - Manual (Page 17)

E D D Y C U R R E N T B R A K E I N S T A L L A T I O N
Eddy Current Brake Installation
Version 2 Model 224 Pit Eddy Current Brake Installation and User Guide
1-13
3 Place one nylon loop strap around the brake shaft with the yoke. Keep the strap
close to the bearing.
4 Place one nylon loop strap around the other side of the brake shaft. Keep the
strap close to the bearing.
Dynojet recommends using single loop style straps.
5 Place the nylon loop straps around the forklift forks.
6 Slide the forklift forks together until the straps angle inward. This will prevent the
straps from slipping off the brake shaft.
7 Using the forklift, lift the eddy current brake from the crate and place the brake in
the pit next to the dyno.
Figure 1-9: Remove the Brake from the Crate
shaft
straps
yoke