EFCO Sliding Glass Door User Manual
Page 18
EFCO CORPORATION 6/8/2012 PART NO. YW41
Page 18 of 59
SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
Locate 3236 and 3247 jambs. Adhere H075 head gaskets and H017 (S-2000) or H073 (S-3000) sill
gaskets to the jambs. Gaskets have pressure sensitive adhesive on one side of the gasket. Match up the
holes in the gasket with the holes in the jambs and adhere to the jamb.
Locate 3491 head and 3320 (S-2000) or 3234 (S-3000) sill. Fasten the head and the sill to the jambs with
SLQ6 screws (#8 x 1 ¼” PL-PH-SMS 410 B-LP MG).
For proper door operation, position the doorframe in the opening by using shims as needed to ensure that
the frame is plumb, square, and level without warp, twist, or bow.
Head
Jamb
Jamb
Sill
EW65
Threshold
3390
3492
H017 Gasket (S-2000)
H073 Gasket (S-3000)
(adhere to the jamb)
H075 Gasket
(adhere to the jamb)
Interior
Exterior
Setting Channel
F132 Shown
Lay the setting channels (F132 S-2000
or FD28 S-3000) in the outside sill
track at approximate quarter points of
the fixed panel.