EFCO Sliding Glass Door - Manual (Page 53)

EFCO CORPORATION 6/8/2012 PART NO. YW41 Page 53 of 59
SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
STK5
3933 Head
Closure
SFP1
Fixed Panel
HEP4
Before installation of the fixed panel, run
a bead of silicone at this intersection, on
both jambs. Do this at the head and sill.
Locate HEP4 setting chairs. The setting chairs will
be quarter pointed the width of the fixed panel. Set
the setting chairs in silicone to prevent movement
when installing the fixed panel.
Locate the fixed panel and install the fixed panel
into the doorframe on the operable jamb side of the
door. Locate 3933 head closure and install into the
head. Through existing holes in the head closure,
fasten STK5 tek screws (#10-16 x ¾” PL-PH 410
tek). Move the fixed panel into the fixed jamb and
finish installing the STK5 tek screws in the head.
There will be two countersunk holes located at the
interior side of the head, where the meeting rail of
the fixed panel tucks into the head. After obtaining
the 13/16” dimension (shown on the following page)
at the jamb, match drill through the two countersunk
holes with a 5/32” drill bit. Fasten SFP1 screws
(#10-15 x 1” PL-FH-SMS 18-8) through the two
countersunk holes.