EFCO Sliding Glass Door - Manual (Page 58)

EFCO CORPORATION 6/8/2012 PART NO. YW41 Page 58 of 59
SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
OXO Locking Side Fixed Panel Meeting Rail Installation: (Does not pertain to OX, XO, or OXXO doors):
Locate OXO meeting rail. This rail will be attached to the fixed panel by match drilling through existing
holes on the meeting rail to the fixed panel meeting rail. Fasten with STS0 screws (#12-14 x 3/4” PL-PH-
SMS 410 tek).
Install threshold in the exterior track of the sill between the two fixed meeting rails.
The 3936 rail will have a notch at the head and sill end. Pump sealant in the area shown at the head and
sill. The sealant needs to cover the joint where the vertical intersects with the head and sill. Tool sealant
with a flat object. After sealant has been tooled, snap 3937 closure into place.
Hardware Adjustment:
Adjust the rollers for a plumb and equal sight line with the fixed lite panel.
STS0
3936 Fixed Panel
Meeting Rail
3937 Closure
Sealant
Notch