EFCO Sliding Glass Door - Manual (Page 28)

EFCO CORPORATION 6/8/2012 PART NO. YW41 Page 28 of 59
SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
Located at the interior side of the head, where the meeting rail of the fixed panel tucks into the head, there
will be two holes. After obtaining the 2 1/16” dimension at the jamb, match drill through the two holes with
a 5/32” drill bit. Fasten SFP1 screws (#10-16 x 1” PL-FH-SMS 18-8) through the two holes. (Fig Q)
Through existing holes in the jamb, attach STK5 screws (#10-16 x 3/4” PL-FH-SMS 410 tek). After the
STK5 screws are attached in the jamb, slide die #3190 cover over the fasteners.
Jamb Cam
STK5
3190
2 1/16”
HV95 3/16” spacer
siliconed in place at
quarter points.
This dimension must be obtained to ensure
proper embedment of the fixed panel;
thereby, ensuring proper interlock of the
meeting rail.
Fig. “Q”
Fasten SFP1 screws
after match drilling
from pre-existing
countersunk holes.