EFCO Sliding Glass Door - Manual (Page 40)

EFCO CORPORATION 6/8/2012 PART NO. YW41 Page 40 of 59
SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
Hardware Adjustment:
Adjust the rollers for a plumb and equal sight line with the fixed lite panel.
OXO Locking Side Fixed Panel Installation: (Does not pertain to OX, XO, or OXXO doors):
Locate OXO meeting rail. This rail will be attached to the fixed panel by match drilling through existing
holes on the meeting rail to the fixed panel meeting rail. Fasten with STS0 screws (#12-14 x 3/4” PL-FH-
SMS 410 tek).
Install threshold in the exterior track of the sill between the two fixed meeting rails.
Pump sealant in the area shown at the head and sill. The sealant needs to cover the joint where the
vertical intersects with the head and sill. Tool sealant with a flat object. After sealant has been tooled,
snap 1283 closure into place.
STS0
1J90 Fixed Panel
Meeting Rail
1283 Closure
Sealant