EFCO Sliding Glass Door - Manual (Page 24)

EFCO CORPORATION 6/8/2012 PART NO. YW41 Page 24 of 59
SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
Screen Installation: Locate the screen. Guide the screen rollers through the notches located in the head.
With the screen slightly tilted outward, roll to the operable panel side of the door. Locate 3237 screen sill
guide and position guide as shown. Fasten with STC7 screws (#6-18 x 3/8” PL-FH-SMS 18-8) after match
drilling through existing holes in the sill guide with a 7/64” drill bit. Attach KS45 screen stops, into the
existing holes, located at the screen head rail and the screen sill rail.
OX, XO or OXO Configurations:
To position HK06 screen keeper, position the keeper next to the screen lock and engage the lock into the
keeper. Shut screen until the keeper hits the jamb. Match drill a 9/64” drill bit through the keeper holes.
Fasten the keeper to the jamb with SFP6 screws (#8-15 x 1/2” PL-TH-SMS 18-8).
OXXO Configuration:
To position HK08 screen keeper, position the keeper next to the screen lock and engage the lock into the
keeper. Close both screens together. Match drill a 9/64” drill bit through the keeper holes. Fasten the
keeper to the screen astragal with SFP6 screws (#8-15 x ½” PL-TH-SMS 18-8).
3237 Screen
Sill Guide
Screen Stops