EFCO Sliding Glass Door - Manual (Page 50)

EFCO CORPORATION 6/8/2012 PART NO. YW41 Page 50 of 59
SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
OX, XO or OXO Configurations:
To position HK06 screen keeper, position the keeper next to the screen lock and engage the lock into the
keeper. Shut screen until the keeper hits the jamb. Match drill a 9/64” drill bit through the keeper holes.
Fasten the keeper to the jamb with SFP6 screws (#8-15 x 1/2” PL-TH-SMS 18-8).
OXXO Configuration:
To position HK08 screen keeper, position the keeper next to the screen lock and engage the lock into the
keeper. Close both screens together. Match drill a 9/64” drill bit through the keeper holes. Fasten the
keeper to the screen astragal with SFP6 screws (#8-15 x ½” PL-TH-SMS 18-8).
3167 Screen
Sill Guide
SPZ1
Fastener
KS45
Screen Stop
Screen Installation:
Locate the screen. Guide the screen rollers,
which are located at the head, through the
notches in the 3151 head closure. Roll the
screen to the operable panel side.
Locate the 3167 screen sill guide. Position guide
as shown. Match drill through existing holes in
the 3167 screen guide with a 9/64” drill bit.
Fasten the screen sill guide with SPZ1 screws
(#8-15 x ¾” PL-PH-SMS 18-8).
Attach KS45 screen stops, into the existing holes,
located at the screen head rail and the screen sill
rail.