EFCO Sliding Glass Door User Manual
Page 22
EFCO CORPORATION 6/8/2012 PART NO. YW41
Page 22 of 59
SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
Installing the Threshold: The threshold is shipped long with a notch in both ends for field fit. One of the
notched ends is to fit into the jamb recess, and the other end is to be square cut and fitted against the fixed
panel meeting rail. Snap the threshold into the exterior track of the sill between the jamb and the fixed
meeting rail. Be sure the long lip on the threshold is towards the interior.
Locate and install the operable panel onto the sill track. Position the operable panel to one side of the
door. (See next page for OXO locking side meeting rail installation.) Locate 3390 head closure and install
up into the head. Through existing holes in the head closure, fasten STK5 tek screws (#10-16 x 3/4” PL-
FH-SMS 410 tek). Move the operable panel to the other side of the door and finish installing STK5 screws.
Press HV04 rubber stop into the interior track at the head. One end will butt against doorjamb.
Fixed Panel
Square Cut
End
Notched End
3390 Head
Closure
EW65
Threshold
Operable Panel
STK5
Screws
HV04 Sash
Stop