EFCO Sliding Glass Door User Manual
Page 31
EFCO CORPORATION 6/8/2012 PART NO. YW41
Page 31 of 59
SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
Hardware Adjustment:
Adjust the rollers for a plumb and equal sight line with the fixed lite panel.
Adjust the lock throw to the most extended position by turning the adjusting screw clockwise.
OXO Locking Side Fixed Panel Installation: (Does not pertain to OX, XO, or OXXO Doors): Locate
OXO fixed panel, meeting rail. Install fixed panel meeting rail by setting the meeting rail on the operable
panel side of the Sill. Match drill through existing holes on the meeting rail to the fixed panel meeting rail.
Fasten with SPZ4 screws (#8-15 x 1” PL-FH-SMS 18-8).
Locate 3390 head closure. The length of the closure is shipped long for field fit. Cut the length required for
one side after the meeting rail has been attached. Measure and cut the other side, installing both lengths
into the head. Through existing holes in the head closure, fasten STK5 screws (#10-16 x 3/4” PL-FH-SMS
410 tek). Move the operable panel to the other side of the door and finish installing STK5 screws.
Install threshold in the exterior track of the sill between the two fixed meeting rails. Place notched end of
the threshold toward the locking fixed meeting rail. The other end should be square cut for a tight fit.
3484 Fixed Panel
Meeting Rail
SPZ4
3241 Fixed Panel
Meeting Rail
Set on top of Sill