Rice Lake 320IS Plus Intrinsically Safe Digital Weight Indicator - Installation Manual - Manual (Page 41)

320IS Plus Installation Manual - Configuration 35
Level 3 submenus
GROSSP
NETSP
+RELSP
–RELSP
%RELSP VALUE
TRIP
BANVAL
HYSTER
PREACT
PREVAL
RELNUM
BATCH
PSHACC
PSHTAR
PSHPRN
ALARM
ACCESS
NAME
DIGOUT Configure GROSSP, NETSP, and RELSP setpoints. See Figure 3-8 on page 33 and
Level 4 parameter descriptions.
PAUSE
DELAY
WAITSS PSHTAR
PSHPRN
PSHACC
ACCESS
NAME
DIGOUT
VALUE Configure PAUSE, DELAY, and WAITSS setpoints. See Figure 3-9 on page 33 and
Level 4 parameter descriptions.
COUNTR
AUTJOG
COZ
NMOTON
NRANGE
–GROSS
–NET
BATPRO VALUE
ACCESS
NAME
DIGOUT Configure COUNTR, AUTJOG, COZ, NMOTON, NRANGE, –GROSS, –NET, AND
BATCHPR setpoints. See Figure 3-10 on page 33 and Level 4 parameter
descriptions.
TIMER
CONCUR VALUE
START
END
ACCESS
NAME
DIGOUT Configure TIMER and CONCUR setpoints. See Figure 3-11 on page 34 and Level 4
parameter descriptions.
Level 4 submenus
VALUE number GROSSP, NETSP, RELSP setpoint types: Specifies the target weight value.
DELAY, AUTJOG, TIMER, and CONCUR setpoint types: Specifies, in 0.1-second
intervals, a time value in the range 0–65535.
COUNTR setpoint types: Specifies the number of consecutive batches to be run.
TRIP HIGHER
LOWER
INBAND
OUTBND GROSSP, NETSP, and RELSP setpoint types: Specifies whether the setpoint is
tripped when the weight is higher or lower than the setpoint value, within a band
established around the value, or outside of that band.
In a batch sequence with TRIP=HIGHER, the associated digital output is active until
the setpoint value is reached or exceeded; with TRIP=LOWER, the output is active
until the weight goes below the setpoint value.
BANVAL number GROSSP, NETSP, and RELSP setpoint types with TRIP=INBAND or OUTBND:
Specifies a weight equal to half the band width. The band established around the
setpoint value is VALUE ±BANVAL.
SETPTS Menu
Parameter Choices Description