Rice Lake 320IS Plus Intrinsically Safe Digital Weight Indicator - Installation Manual - Manual (Page 63)

320IS Plus Installation Manual - Setpoints 57
To use batch setpoints, you must activate the BATCHN parameter on the SETPTS menu. This parameter defines
whether a batch sequence is automatic or manual. AUTO sequences repeat continuously, while MANUAL
sequences require a BATSTA digital input, BATSTART EDP command. As shown in Table 7-1 on page 57,
GROSSP, NETSP, and RELSP setpoint kinds can be configured as either batch or continuous setpoints. The
BATCH parameter must also be set on for each batch setpoint. If the setpoint is defined but the BATCH
parameter is off, the setpoint operates as a continuous setpoint, even during batch sequences.
Kind Description Batch Continuous
OFF Setpoint turned off/ignored.
GROSSP Gross setpoint. Trips when the current gross weight matches this value.
 
NETSP Net setpoint. Trips when the current net weight matches this value.
 
+RELSP Positive relative setpoint. Trips at a specific value above the referenced setpoint.
 
–RELSP Negative relative setpoint. Trips at a specific value below the referenced
setpoint.
 
%RELSP Percent relative setpoint. Trips at a specific percentage value of the referenced
setpoint.
 
RESREL Relative to a result setpoint. Performs functions based on a specified
percentage of the captured value of a referenced setpoint, using the same
weight mode as the referenced setpoint. The actual target value of the RESREL
setpoint is calculated as a percentage of the captured value of the referenced
setpoint, rather than the target value.
PAUSE Pauses the batch sequence indefinitely. Operator must activate the BATSTA
digital input to continue processing.

DELAY Delays the batch sequence for a specified time. The length of the delay (in
tenths of a second) is specified on the Value parameter.

WAITSS Wait for standstill. Pauses the batch sequence until the scale is at standstill.

COUNTR Specifies the number of consecutive batch sequences to perform.

AUTJOG Automatically jogs the previous filling operation.

COZ Center of zero. The digital output associated with this setpoint is activated
when the scale is at center of zero. No value is required for this setpoint.

NMOTON In motion. The digital output associated with this setpoint is activated when the
scale is not at standstill. No value is required for this setpoint.

NRANGE In range. The digital output associated with this setpoint is activated when the
scale is within capacity range. No value is required for this setpoint.

–GROSS Negative gross weight. The digital output associated with this setpoint is
activated when the gross weight reading is less than zero. No value is required
for this setpoint.

–NET Negative net weight. The digital output associated with this setpoint is activated
when the net weight reading is less than zero. No value is required for this
setpoint.

ACCUN Accumulate setpoint. Compares the value of the setpoint to the source scale
accumulator. The accumulator setpoint is satisfied when the value of the source
scale accumulator meets the value and conditions of the accumulator setpoint.
BATPRO Batch processing signal. The digital output associated with this setpoint is
activated whenever a batch sequence is in progress. No value is required for
this setpoint.

Table 7-1. Setpoint Kinds