Rice Lake 320IS Plus Intrinsically Safe Digital Weight Indicator - Installation Manual - Manual (Page 58)

52 320IS Plus Installation Manual
5.2 Saving and Transferring Data
Saving and transferring data requires the use of an I/O Module.
Connecting a personal computer to the
320IS Plus
EDP port allows you to save indicator configuration data to the
PC or to download configuration data from the PC to an indicator. The following sections describe the
procedures for these save and transfer operations.
Saving and transferring data requires the optional I/O module. See Section 9.0 on page 72 for more
information on the I/O module.
5.2.1 Saving Indicator Data to a Personal Computer
Configuration data can be saved to a personal computer connected to the EDP port. The PC must be running a
communications program such as ProComm Plus
® 1
or Revolution®. See the I/O Module Installation Manual
(PN 78076) OR, Section 9.0 on page 72, for information about serial communications wiring and EDP port pin
assignments.
When configuring the indicator, ensure that the values set for the BAUD and BITS parameters on the SERIAL
menu match the baud rate, bits, and parity settings configured for the serial port on the PC. Set the PRNDES
parameter to EDP.
To save all configuration data, place the indicator in setup mode and send the DUMPALL EDP command to the
indicator. The
320IS Plus
responds by sending all configuration parameters to the PC as ASCII-formatted text.
5.2.2 Downloading Configuration Data from PC to Indicator
Configuration data saved on a PC or floppy disk can be downloaded from the PC to an indicator. This procedure
is useful when a number of indicators with similar configurations are set up or when an indicator is replaced.
To download configuration data, connect the PC to the EDP port as described in Section 5.2.1. Place the indicator
in setup mode and use the PC communications software to send the saved configuration data to the indicator.
When transfer is complete, calibrate the indicator as described in Section 4.0 on page 41.
Calibration settings are included in the configuration data downloaded to the indicator.
If the receiving indicator is a direct replacement for another 320IS Plus and the attached scale is not
changed, recalibration is not required.
1. ProComm Plus is a registered trademark of Symantec Corporation.
Note
Note
Note