Rice Lake 320IS Plus Intrinsically Safe Digital Weight Indicator - Installation Manual - Manual (Page 51)

320IS Plus Installation Manual - EDP Commands 45
5.1.2 Reporting Commands
Reporting commands (see Table 5-2) send specific information to the EDP port. These commands can be used in
both setup mode and normal mode.
Command Function
KZERO In weighing mode, press the ZERO key
KGROSSNET In weighing mode, press the GROSS/
NET key
KTARE Press the TARE key
KUNITS In weighing mode, press the UNITS key
KPRINT In weighing mode, press the PRINT key
KLEFTARROW In setup mode, move left in the menu
KRIGHTARROW In setup mode, move right in the menu
KUPARROW In setup mode, move up in the menu
KDOWNARROW In setup mode, move down in the menu
K0-K9 Enters the number in the entry buffer,
used for keyed tare entry.
KDOT Press the decimal point (.)
KENTER Press the ENTER key
KEXIT Exit setup
KSAVE Saves configuration without exit
KSETPOINT *Display setpoint configuration
KTIMEDATE *Display time and date
KTIME *Display time
(pseudo key)
KDATE *Display date
(pseudo key)
KDISPACCUM Press ACCUM key
KCLRACCUM Clears accumulated register
KDISPTARE Display tare
(pseudo key)
KID Display unit ID entry screen
KCOUNT Go to piece count mode

(pseudo key)
KCLR Press the CLEAR key
* I/O module required
Table 5-1. EDP Key Press Commands
Command Function
DUMPALL List all parameter values
SPDUMP List all setpoints
IOVERSION Display I/O Module software version
P Display current displayed weight with units
identifier. See Section 8.2.1 on page 62 for
more information.
Table 5-2. EDP Reporting Commands