7 batching control commands, Batching control commands – Rice Lake 920i USB Installation Manual V5.05 User Manual
Page 110
104
920i Installation Manual
10.1.7
Batching Control Commands
The commands listed in Table 10-14 provide batching control through the serial port.
Table 10-14. Batching Control Commands
Command
Description
Values
BATSTART
Batch start
If the BATRUN digital input is active (low) or not assigned, the BATSTART
command can be used to start the batch program.
BATSTOP
Batch stop
Stops the batch program and turns off all associated digital outputs.
BATPAUSE
Batch pause
Stops the batch program at the current step. All digital outputs set on by the
current step (except for those set by concur setpoints) are set off. The BATSTRT
DIGIN, BATSTART serial command, Batch Start softkey, or the StartBatch
function in an
iRite
program can be used to restart the batch program at the
current step.
BATRESET
Batch reset
Stops the program and resets the batch program to the first batch step. Run the
BATRESET command after making changes to the batch configuration.
BATSTATUS
Batch status
Returns XYYY where X is S (if the batch is stopped), P (if the batch is paused),
R (if the batch is running); and YYY is the setpoint number the batch is currently
on (1-100).