Rice Lake MSI-8000 RF Remote Display - ScaleCore Configuration Management Program (ScCMP) - Manual (Page 11)

Views 7
3.2 Data Views
The data views provide a read-only display of all sensor data. Sensors include weight, math, temperature and
voltage.
At the bottom of this display are setpoint indicators for three setpoints.
3.2.1 LC/Math Sensor Data
The LC/Math Sensor data view shows weight including ADC count, calibrated weight value with indicators
(motion, CoZ) and total/statistics data.
Figure 3-3. Data View – LC/Math
Table 3-1. LC/Math Sensor Data Parameters
Parameter Description
Sensor ID Sensor index. Typical range 0 to 4 for load and math sensors.
Status
Current status of the sensor. This will indicate under load, overload, under range, over range, disabled, and
other sensor status messages.
ADC Count The ADC (Analog to Digital Converter) count as read from the sensor input.
Gross Weight The calibrated gross weight value.
Net Weight The calibrated net weight value.
Tare Weight The current tare weight value.
Units The current unit of measure.
Motion Indicates motion on the sensor input.
CoZ Center of Zero indication for the sensor Net Mode Indicates if the scale is currently in net or gross mode.
Total The total accumulator value.
Stat. SumSqr Calculated statistics value based on the total feature.
Stat. Num Ttl Number of totals registered in the total accumulator.
Stat. Min Ttl The minimum total value recorded in the accumulator.
Stat. Max Ttl The maximum total value recorded in the accumulator.
Note ADC, total and statistics may not be updated if the monitor is not enabled from the Edit menu.