3 voltage, Voltage – Rice Lake MSI-8000 RF Remote Display - ScaleCore Configuration Management Program (ScCMP) User Manual
Page 13
Advertising
Views
9
3.2.3
Voltage
A ScaleCore device may have voltage sensors. Typically these are used for monitoring power (battery) levels. The
meaning of each voltage sensor is dependent on the device.
Please refer to the specific device User Guide for more details.
Figure 3-5. Data View - Voltage
Note
The voltage data will not be updated if the monitor is not enabled from the Edit menu.
Parameter
Description
Sensor ID
Typical range 5-7 for voltage sensors.
Status
Current status of the sensor.
Value
The measured voltage value.
Units
The current units of measure (Volt).
Table 3-3. Voltage Parameters
Advertising
This manual is related to the following products: