2 connection state, Connection state – Rice Lake MSI-8000 RF Remote Display - ScaleCore Configuration Management Program (ScCMP) User Manual
Page 8
4 ScCMP Operator’s Manual
2.2.2
Connection State
When a connection is first opened, the ScCMP application is
Searching
state, searching the communications
interface for an attached ScaleCore device.
The application will continue to search the interface for a device indefinitely, or until the communication
connection is closed.
Figure 2-4. Searching Screen
When a device is found (a response is received), ScCMP will transition to the
Discovery
state. During which
ScCMP is reading the device configuration. This will typically take 2 to12 seconds depending on the
communications speed.
Figure 2-5. Reading Device Screen
After the device configuration has been read, ScCMP will transition to the
Normal
state. The normal state allows
selection of one of the four device views, detailed in the next section.
Additional information on the connection state can be found under the Event Monitor section (see Section 3.1.1).