0 installation, 1 system requirements, 2 getting started – Rice Lake MSI-8000 RF Remote Display - ScaleCore Configuration Management Program (ScCMP) User Manual

Page 6: 1 making a connection, Installation, 1 system requirements 2.2 getting started, Making a connection

Advertising
background image

2 ScCMP Operator’s Manual

2.0

Installation

The ScaleCore Configuration Management Program (ScCMP) is distributed in the default configuration for

Microsoft Windows

®

operating system.

Using the compressed (zip) file, unzip the program to a location on the local computer and run the application. The
location of the executable is referenced as the

installation folder

throughout this manual. There is no further

installation required for the application.

2.1 System Requirements

Specifications subject to change without notice.

Typical

Typical Operating System include:

• Windows XP

®1

• Windows Vista

®1

• Windows 7

®1

• Windows Embedded
• Disk Usage: <200MB
• Display: 800x600 or greater

Note

Additional operating systems may be supported with the restriction of requiring TCP/IP device communications
exclusively (no RS-232 serial communications supported). Please contact MSI for details.

2.2 Getting Started

ScCMP supports interfacing to MSI ScaleCore products from serial (RS-232) or TCP/IP sockets via Ethernet
(802.3) or WiFi (802.11). The connection depends on the available interfaces of the particular ScaleCore product
being used. Please refer to your specific device manual for more details on the interface capabilities.

2.2.1

Making a connection

The ScaleCore device has an auto detect feature for serial interfaces.

1. Select

File,

then

Auto Detect Serial.

The ScCMP will automatically scan all available serial ports for any

attached ScaleCore devices. When the scan is complete ScCMP will display the detected devices.

Figure 2-1. Auto Detect Serial Results Dialog

2. Select the device desired.

3. Press the

Open

button to begin communicating with the device.

Note

If your device is not found, close the dialog, check the device power and data connection to the computer, then
run the scan again.

1. Microsoft, Encarta, MSN, and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries.

Advertising