Rice Lake MSI-8000 RF Remote Display - ScaleCore Configuration Management Program (ScCMP) - Manual (Page 9)

Views 5
3.0 Views
The ScCMP application provides four main views when communicating with a ScaleCore device.
• Configuration View – All device configuration and setup controls are accessed from this view.
• Data View – A complete view of all measured sensor data by the device.
• Single Meter – A virtual meter for a single load sensor system.
• ABC Meter – A virtual meter for dual load systems that provide three simultaneous load sensor views to
monitor both load points, and a sum.
3.1 Configuration View
The configuration view of the active device provides a complete view of the ScaleCore device settings. This
interface is divided into tabbed panels that separate the different ScaleCore parameters into logical groups. Each
panel provides controls for entering configuration, viewing the current configuration settings and performing
related functions.
Figure 3-1. Configuration View
Complete details on advanced device configuration can be found in Section 6.0.
3.1.1 Event Monitor
The event monitor is located at the bottom of the ScCMP configuration view. This provides a log of activities that
the ScCMP application is performing, plus statistics on the communications interface to monitor when
communication interruptions occur.
Figure 3-2. Event Monitor