Rice Lake DWM-IV Weighmeter Series 9 Setup Manual - Manual (Page 10)

8
q Programming Recall Tare Values (Optional Series 9, if enabled)
(1) The optional Series 9 can maintain up to 10 predefined Tare
values.
(2) To program a tare value press [Shift] and then [8]. The display
will prompt [T 0-END] and then [t no. 1]
(3) Key in the desired tare register number (1-10) and press [Enter].
(4) The display will prompt [T XXX.XX]
(5) Enter the desired tare value.
(6) To Exit programming tare registers, enter ‘0’ at the tare register
prompt.
q Recalling a Tare Value (Optional Series 9, if enabled)
Enter the desired tare register (1-10) then press the
[Select/Enter] key. In sealed applications this function is only
available when the gross weight is at zero.
q Preset Output Settings (Optional Series 9, if enabled)
. Press [SHIFT] then press [ 9 ],
The display will prompt [S XXX.XX]. Key in the Start value for
Set point 1 and press [Enter],
The display will prompt [E XXX.XX]. Key in the End value for
Set point 1 and press [Enter]
Repeat the above sequence for Set point 2.