Rice Lake DWM-IV Weighmeter Series 9 Setup Manual - Manual (Page 29)

27
Journal Print Format Key Operation
Following procedures are only available when the Custom Print Format contains the
specific Journal Print Format as described in the previous section. It requires 3 ma in
printing steps to complete the Operation, i.e. (1) Batch Weighing, (2) Sub Total and
(3) Grand Total as foll ows:
How to print the Batch Weighing:
1) Before starting the first weighing of each new batch, enter the Product Code (10
alpha-numeric characters) by using the Function Key [ F1] (Press [Shift] then
press [1]).
Note:
§ Enter the Product Code in the same way as editing the Custom Print Format in
C10.1.
§ To Delete all characters of Product Code at once, press [ Shift] then press
[Clear].
§ The Function Key [F1] is automatically enabled when the Sub Title Format
(F2) contains the Product Code (N1) command.
2) Perform a consecutive batch weighing as usual, i.e. when the weight becomes
stable, either Manually Print or an Auto Print should be issued depending on t he
setting in C3.7 “PRM”. Following conditional print formats will be printed:
(i) Main Title Prin t Format (F1):
Printed only once at the start of the First Batch Weighing. Normally the
Company Name is printed here.
(ii) Sub Title Pri nt Format (F2):
Printed only once at the start of each New Batch Weighing. Normally
Date/Time and Product Code is printed here.
(iii) Batch Weighing Format (F3):
Once the above two conditional formats are printed, each weighing in a batch
will be printed consecutively. Normally Consecutive No . and Net Weig ht with
current selected unit are printed he re. After printing, the foll owing data will be
updated:
a) Consecutive No. (N2) will be increased by one.
b) Sub Total Count (N3) will be increased by one.
c) The Printed (Net) Weight ( W0) will be accumulate d to the Sub Total
Weight (W3)
3) Continue the next consecutive weighing as described in step (2.iii) if required.
4) For the last Batch Wei ghing, issue the Sub Total Data Print as shown below.
How to print the Sub Total:
After printing the last weighing of ea ch batch, issue the Sub Total Data Print as
follows:
1) Press [Shift] then press [Print].
2) The Sub Total Print Format (F4) Data will be printed. Normally line separator,
Sub Total Data e.g. Accumulated Counts ( N3) and Accumulated Weight ( W3) will
be printed here.
3) After printing the Sub Total Data, the fo llowing will be reset:
a) Consecutive No. (N2) will be reset to one.
b) Sub Total Count (N3) will be cleared to zero
c) Sub Total Weight (W3) will be cleared to zero.
4) Continue the next batch with the above How to print the Batch Weighing if
required.
5) For the last batch Sub Total prin ting, issue the Grand Total Data Print as shown
below.