Rice Lake DWM-IV Weighmeter Series 9 Setup Manual - Manual (Page 13)

11
Configuration/Calibration Menu Choices
v C1 Misc.
Ø C1.1 [DPM] Display Mode
Ø C1.2 [HKY] Hot-key
Ø C1.3 [ATS] Auto Power Off Time
Ø C1.4 [DTM] Power On Countdown Date/Time Settings Enable
Ø C1.5 [JPR] Journal Printer: Sub Total, Grand Total Functions
Enable
v C2 Key Enables
Ø C2.1 [UNE] Unit Toggle Key Enable
Ø C2.2 [TAM] Tare Key Mode
Ø C2.3 [TZE] Allow Keyboard Tare and Recall Tare at Zero
Ø C2.4 [PS1] Preset Output 1 Enable
Ø C2.5 [PS2] Preset Output 2 Enable
v C3 Communications
Ø C3.1 [ADR] Instrument Address
Ø C3.2 [CHN] Communication Channel (Port)
Ø C3.3 [BDR] Baud Rate Selection
Ø C3.4 [PAR] Data Bits and Parity
Ø C3.5 [TYP] Serial Type
Ø C3.6 [PFM] Print Format
Ø C3.7 [PRM] Print Mode
Ø C3.8 [MIN] Minimum Print Value
Ø C3.9 [CHW] Weight Change Window
v C4 Filter / Motion
Ø C4.1 [AVG] Average (Digital Filter)
Ø C4.2 [MOW] Motion Window
Ø C4.3 [MOT] Motion Time
v C5 Pre-Calibration
Ø C5.1 [CUN] Calibration Unit
Ø C5.2 [SUN] Secondary Unit
Ø C5.3 [MET] Metrology Method
Ø C5.4 [DP] Decimal Position
Ø C5.5 [CAP] Capacity
Ø C5.6 [DIV] One Division Increment Size
Ø C5.7 [AZT] Auto Zero Tracking
v C6 Calibration
Ø C6.1 [REF] Reference Calibration Mode
Ø C6.2 [PCAL] Zero Point Calibration (Reference Calibration)
Ø C6.3 [CAL] Span Calibration
v C7 Calibration Tune
Ø C7.1 [TUN] Calibration Tune
Ø C7.2 [DIR] Direction
v C10 Print Formatting (Full Keypad Option Only)
Ø C10.1 [P1 CUST] Edit Custom Print Format
Ø C10.2 [P2 CONT] Edit Custom Continuous Output Format
Ø C10.3 [FMT END] Exit from Custom Format Editing