Rice Lake DWM-IV Weighmeter Series 9 Setup Manual - Manual (Page 14)

12
q Default settings are highlighted.
Category
Selection
Values Description
C1 Firmware Function Settings
DPM Display Mode
WET Normal Weighing Mode Display
ADC A/D Raw Counts Display
BAT Battery Voltage Display
Secondary Remote Display Unit (Requires Optional Series 9
unit to be setup as Main Displa y Unit with C3.6 “PFM” = RDP)
RDP
Connecting the Remote Displays Communication Channel 1
(COM1) to the Main Displays COM1 allows remote key entry
Secondary Remote Operation Unit. This setting will allo w the
remote access of Di splay, Keyboard and Printer from/to a Main
Unit. Requires Optional Series 9 unit to be setup as a Main
Unit with the Remote P rinter Type on COM1 (C3.5 “TYP”=RP)
and a desired Print Format (C3.6 “PFM”=SIN, MUL or CPR)
C1.1
ROP
Also requires Bi -directional Communication be tween Main and
Remote Unit s (COM1 ••COM1) and a Printe r is attached to
this Remote Unit on COM2 with a Baud Rate setting in C3.3
HKY Hot-key Enable (Allo ws front panel password entry to setup)
D Disabled C1.2
E Enabled
ATS Auto Power Shutd own (Off) Time (In Batt ery Operated Mode)
1~255 1 = 1 minute C1.3
0 Auto Power Shutdown Disabled
DTM Power On Count Down Date/Time Setti ngs Enable
D Disabled C1.4
E Enabled
JPR Journal Printer: Sub Total, Grand Total Functions Enable
D Disabled C1.5
E Enabled
C2 Function Keys Enable
UNE Allow Unit Key Toggle
D Disable C2.1
E Enable
TAM Tare Key Mode
D Disable
P Enable Push Button Tare Key (Default for std. Series 9 Unit)
N Enable Numeric Tare Entry (Optional)
C2.2
NP Enable Numeric Tare Entry and Pushbutton Tare (Optional)