Rice Lake DWM-IV Weighmeter Series 9 Setup Manual - Manual (Page 17)

15
Configuration
Step
Values
Set
Description
Print Response Retry Time-out for the bi-directional Remote
Printer Communication
TMO
This choice is only avai lable when setting C3.5 “TYP”=RP
0 Disable (Use Internal Default Retry Time-out)
C3.10
1~255 1=10 milliseconds (Should be at least 5=50ms)
C4 Filter/Motion
AVG Average, Digital Filter
C4.1
1 ~ 8 Default = 4 (8 = Maximum Stability)
MOW Motion Window (1 = 0.5 Division)
0 = No Motion Check
C4.2
0~255
Default = 1
MOT Motion Time ( 1 = 0.1 sec )
C4.3
0~255 Default = 5
C5 Pre-calibration
CUN Calibration Unit Selection
KG To Calibrate by kilogram “kg”
LB To Calibrate by pound “lb”
G To Calibrate by gram “g”
C5.1
OZ To Calibrate by ounce “oz”
SUN Secondary Conversion Weight Unit
KG To set secondary weight unit as kilogram “kg”
LB To set secondary weight unit as pound “lb”
G To set secondary weight unit as gram “g”
C5.2
OZ To set secondary weight unit as ounce “oz”
MET Metrology Method
OIM OIML (F.S. Capacit y + 9 divisions, 2% Zero Range, etc.) C5.3
USA USA (F.S. Capacity + 5%, 100 % Zero Range, etc.)
DP Decimal Point Position
C5.4
0 ~ 4 Default = 0, (No Decimal Point)
CAP Capacity Setting
C5.5
Display will show “C XXX.XX”, Default = 10000 l b
DIV Count-by
Default = 1.
C5.6
1, 2,
5,10,
20, 50,
100
Select any one of 1, 2, 5, 10, 20, 50 and 100.
AZT Auto Zero Tracking Width (In Divisions)
OFF Auto Zero Tracking function is OFF
0.5D
To
C5.7
3.0D
Select any one of 0.5D through 3.0D