Rice Lake DWM-IV Weighmeter Series 9 Setup Manual - Manual (Page 15)

13
Configuration
Step
Values
Set
Description
R Enable Recall Tare (Optional)
RP Enable Recall Tare and Pushbutton Tare (Optional)
RN Enable Recall Tare and Numeric Tare Entry (Optional)
C2.2
RNP
Enable (Recall Tare, Numeric Tare and Push Button Tare)
(Default for Optional Series 9)
TZE Allow Keyboard Tare and Recall only at zero
D Disable (Tare and Recall availabl e at any weight) C2.3
E Enable (Tare and Recall avail able only at zero)
PS1 Preset 1 Output Enable
OFF Disable
A0 Enable with normally Inactive Output Signal
C2.4
A1 Enable with normally Active Output Signal
PS2 Preset 2 Output Enable
OFF Disable
A0 Enable with normally Inactive Output Signal
C2.5
A1 Enable with normally Active Output Signal
C3 RS-232C Communications and Printings
ADR
Instrument Address (to be used with external RS -232 / RS-485
Level Converter)
C3.1
0~255 Default = 0
CHN RS-232C Communication Port Selection
Leave selection blank exit communications setup
CH_
If CH1 or CH2 is selected continue Steps C3.3 through C3.9
CH1 Setup channel one
C3.2
CH2 Setup channel two
BDR Baud Rate Selection
12 Baud Rate Set to 1200
24 Baud Rate Set to 2400
48 Baud Rate Set to 4800
96 Baud Rate Set to 9600
C3.3
192 Baud Rate Set to 19200
PAR Data Bit Size and Parity Setting
8N 8 Data Bit – No Parity
7E 7 Data Bit - Even Parity
C3.4
7O 7 Data Bit - Odd Parity
TYP Serial Type – Serial or Printer
SR Default setting for channel 1 (Serial)
C3.5
PR Default setting for channel 2 (Printer)