Rice Lake IQ plus 590-DC Installation Manual - Manual (Page 12)

8 IQ plus 590-DC Installation Manual
2.6 AC Adapter
The AC adapter can be used to provide power to the
indicator if battery power is low and AC power is
available. Use only the adapter supplied with the
indicator.
To use the AC adapter, do the following:
1. Remove the top screw from the AC adapter
port cover.
2. Loosen the bottom screw, then rotate the port
cover to expose the AC adapter port (see
Figure 2-6).
3. Reinstall the top screw in the backplate.
4. Plug AC adapter from power outlet to the
indicator adapter port.
Close the adapter port cover and reinstall screws as
described in Section 2.4 when not using the AC
adapter.
The IQ plus 590-DC enclosure cannot
be rated for NEMA 4X/IP66 applications
with the AC adapter port cover open.
Do not use the AC adapter in washdown environments.
Figure 2-6. AC Adapter Port Cover
2.7 Board Removal
If you must remove the IQ plus 590-DC CPU board,
use the following procedure:
1. Disconnect power to the indicator. Loosen
cord grips and remove backplate as described
in Section 2.2 on page 5.
2.8 Replacement Parts
Table 2-3 lists replacement parts for the IQ plus 590-DC, including all parts referenced in the assembly drawing
(see Figure 2-7 on page 10).
Caution
Ref
Number PN Description (Quantity)
1 49520 Battery cover thumb screws (4)
— 47939 Battery cover - old style 4 x 4.5 " dimension (1)
2 71352 Battery cover - new style 3 x 7 " dimension (1)
— 49557 Battery cover gasket - old style (1)
3 71354 Battery cover gasket - new style (1)
— 49909 Battery holder assembly (1)
4 71448 Battery holder assembly (1)
5 19538 Cable grip plug (1)
6 42640 Setup switch access screw, 1/4 x 28NF x 1/4 (1)
7 15626 Cable grips, PG9 (2)
8 44676 Sealing washer for setup switch access screw, #14 (1)
9 30375 Nylon seal rings for cable grips (2)
10 14862* Screws, 8-32NC x 3/8 (2)
11 45042 Sealing washers, #8 (3)
— 51970 Enclosure backplate - old style (1)
12 71435 Enclosure backplate - new style (1)
13 15627 Locknuts, PCN9 (2)
14 52382 Backplate gasket (1)
Table 2-3. Replacement Parts