Rice Lake IQ plus 590-DC Installation Manual - Manual (Page 7)

Introduction 3
1.3 Display Annunciators
The IQ plus 590-DC display uses a set of LCD
annunciators to provide additional information about
the value being displayed. Figure 1-2 on page 3 shows
these annunciators and their meanings.
G
The displayed weight is a gross weight.
N
The displayed weight is a net weight.
Scale is at standstill or within the specified motion
band. Some operations, including zero, tare, and
printing functions, can only be done when the
standstill symbol is shown.
C e n t e r o f z e r o . G r o s s w e i g h t i s w i t h i n 0 . 2 5
graduations of zero. This annunciator lights when the
scale is zeroed.
Indicates that a tare has been entered. The tare value
can be entered by pressing the
TARE key on the
keypad or by sending the KTARE EDP command. See
Section 5.0 on page 25 for information about the EDP
command set.
Indicates that the battery charge is low.
lb, kg, PC
Three arrow annunciators on the right side of the LCD
display indicate the units associated with the
displayed value. The bottom arrow annunciator (PC)
is lit when the indicator is in piece count mode. The
top and middle arrows, labeled lb and kg, show
primary and secondary units, as described below:
• If the displayed weight is in pounds, the top arrow
(lb) is lit; if kilograms, the middle arrow (kg) is
lit.
• If the primary unit of weight is pounds, the middle
(kg) arrow is lit for secondary units—or, if the
primary unit is kilograms, the top (lb) arrow is lit
for secondary units, unless the secondary unit of
weight is the same as the primary unit.
• If neither primary nor secondary units are pounds
or kilograms, the top arrow is used as a primary
units annunciator and the middle arrow is used as
t h e s e c o n d a r y u n i t s a n n u n c i a t o r. A s e t o f
replacement overlay decals is included in the parts
kit for units other than pounds and kilograms.
See Section 3.2.2 on page 16 for information about
configuring primary and secondary display units.
Figure 1-2. IQ plus 590-DC Display Annunciators
Gross mode
Net mode
Standstill
Center of zero
Tare in system
Low battery
lb
kg
PC
Displayed units
Secondary
Primary
Piece count mode