Rice Lake IQ plus 590-DC Installation Manual - Manual (Page 24)

20 IQ plus 590-DC Installation Manual
3.2.5 Program Menu
Figure 3-8. ProgramMenu
XXXXXXX XXXXXXX
PWRUPM
GO NONE
OIML
REGULA
000000
number
CONSNU
DELAY
VERS PROGRM PFORMT SERIAL CALIBR CONFIG FORMAT
000000
number
CONSTU
NTEP
CANADA
1
number
UID STNDBY COUNT
SBYDLY LSTMOD ACCESS SPLSIZ
10
20
50
100
5
DSABLE
ENABLE
0
number
YES
NO
PROGRM Menu
Parameter Choices Description
Level 2 submenus
PWRUPM GO
DELAY Power up mode. In GO mode, the indicator goes into operation immediately after a brief power
up display test.
In DELAY mode, the indicator performs a power up display test, then enters a 30-second
warm up period. If no motion is detected during the warm up period, the indicator becomes
operational when the warm up period ends; if motion is detected, the delay timer is reset and
the warm up period repeated.
STNDBY SBYDLY
LSTMOD Specifies standby mode delay and whether indicator returns to the last operating mode or
performs a power-up sequence when standby mode ends. See Level 3 submenu parameter
descriptions.
COUNT ACCESS
SPLSIZ Specifies whether operator has access to piece count mode and the default sample size used
for parts counting. See Level 3 submenu parameter descriptions.
Table 3-6. Program Menu Parameters