3 front panel configuration, Using the menus is described in section 3.1.3, Setup mode key functions – Rice Lake IQ plus 590-DC Installation Manual User Manual
Page 16
12
IQ plus 590-DC Installation Manual
3.1.3
Front Panel Configuration
The IQ plus 590-DC indicator can be configured using a series of menus accessed through the indicator front
panel when the indicator is in setup mode. Table 3-1 summarizes the functions of each of the main menus.
Figure 3-2. Front Panel Key Functions in Setup Mode
Menu
Menu Function
CONFIG
Configuration
Configure grads, zero tracking, zero range, motion band, overload, tare function, sample rate,
and digital filtering parameters.
FORMAT
Format
Set format of primary and secondary units, display rate.
CALIBR
Calibration
Calibrate indicator. See Section 4.0 on page 23 for calibration procedures.
SERIAL
Serial
Configure serial port.
PROGRM
Program
Set power-up and standby modes, counting scale functions, regulatory mode, unit ID and
consecutive number values.
P FORMT
Print Format
Set print format used for gross, net, and counting scale tickets. See Section 7.0 on page 31
for more information.
VERSION
Version
Display installed software version number.
Table 3-1. IQ plus 590-DC Menu Summary
T
4
9
0
8
5
2
7
6
3
CLEAR
DISPLAY
TARE
ZERO
GROSS
NET
TARE
UNITS
B/N
Units
POWER
ENTER
SAMPLE
MODE
I / O
Move LEFT /
Previous
Move RIGHT /
Next
Move UP /
Increment Value
Move DOWN /
Decrement Value
ENTER Value
SETUP MODE KEY FUNCTIONS
T