Rice Lake MSI-8000HD Remote Display - Manual (Page 41)

Appendix 37
Display reading
not stable Excessive vibration Increase filtering or increase ‘d’ in Cal
Excessive side
loading Improve load train symmetry
Load cell faulty Check LC connections
Display toggles
between “Error”
and “Load” Load exceeds
capacity Reduce tension immediately
Faulty Load cell or
wiring Check LC and LC wiring
Display toggles
between “Error”
and “buttn” A key is stuck or is
being held down Check switches for damage
Weight is on the
Scale/Dyna-Link,
RF Remote
Display does not
match Units not mated See setting the RF Network address
procedures
Lo Batt is blinking Battery is low Recharge Battery
Unit turns on,
then immediately
off Battery is low Recharge Battery
Load will not zero System not stable
Wait for stable symbol to turn on
Increase filtering for more stability
Zero out of range Zero range might be limited. Reduce the
tension or use Tare instead
Load will not Tare
or Total System not Stable
Wait for the stable symbol to turn
on, or if in a mechanically noisy crane,
increase the filtering or reduce the size of
the Scale increment “d.” It is also possible
to increase the motion window. Contact
MSI if you have a problem getting the
8000 to zero, tare, or total due to stability
issues
Set point lights
blink Set point is enabled
and the trigger point
has been reached Disable set points if they are not needed
Manual Total does
not work A function key is not
set to “total” Set up Func1 or Func2 for “total”
Tension must be
stable Increase filtering for more stability
Problem Possible Cause Solution
Table 6-1. Troubleshooting