Rice Lake MSI-8000HD Remote Display - Manual (Page 9)

Introduction 5
1.3 Specifications
Accuracy
Power
Display
Operating Temp
Operating Time
Enclosure
F1, F2, and F3
Calibration
Auto-Off Mode
Units
Totalization
Set Points
Weight accuracy is dependent on the linked load unit, a Dyna-Link
or MSI Crane scale. Refer to the appropriate User Guide for
accuracy specifications. The MSI-8000 mirrors the display of the
connected device.
Battery operated by a custom Lithium Polymer cell. Not user
replaceable. Estimated number of charges is >300. Life is
prolonged with frequent recharging and not allowing the deep
discharging of the battery.
6 digit, 1 in (26 mm) numeric digits
- 40°F to +122°F (-40°C to +50°C), Rated accuracy range -10°C
to +40°C.
>24 hours typical.
NEMA 4/IP65 with charger port plug installed.
Programmable multifunction buttons for use as TEST, TOTAL,
Total Remote Devices, PEAK, TARE, NET/GROSS, VIEW TOTAL,
PRINT and High Res mode
No Calibration parameters are stored in the MSI-8000HD .
However, it can be used to calibrate an RF connected scale
Prolongs battery life by turning the power off after 15, 30, 45, or
60 minutes (operator determined) of no weight activity
kg, lb, Tons (US short ton), Metric Tons, kiloNewtons (other Units
available with custom calibrations). Available units are determined
by the RF Linked Scale/Dyna-Link
Standard: Press button or Automatic; TOTAL weight up to 99999
X 1000 units
Two internal Set Points with open drain outputs, and two
ultrabright LEDs on indicator panel.