Smart Power Systems ER Series - Manual (Page 14)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 13 of 52
WARNING:
Do not install hose ends until proper hose length has been determined.
Never install a hose in a location where it will rub against another surface or
abrasion member.
Do not position hoses with tight bend radii. Consult the hose manufacturer’s
installation guidelines. Tight bends may kink and cause serious damage to the
system and will void the system’s warranty.
Use caution when tightening the hose ends to prevent the hose from becoming
twisted.
Never install a 90° fitting at the pump inlet or outlet. Avoid the use of flow
restricting fittings.
Do not form loops in the hose that may collect air or kink. Run hoses as straight as
possible (but not taut) between connections.
Do not exceed hose lengths of 20 feet.
6.
SPS models ER-6.2, ER-8, ER-10 and ER-110 can be mounted on top of a vehicle,
in the open, without requiring any additional coverings. Reference Error!
Reference source not found., Error! Reference source not found., Figure 3,
and Figure 4 for the minimum clearances around the perimeter of the generator’s
tray assemble. Also, do not position any obstructions directly in front of the
system’s oil cooler. If the system cannot be installed without maintaining the
minimum clearances as indicated, or if you have any questions relative to the
installation of these systems, contact Smart Power
®
Systems at (231) 832-5525.