Smart Power Systems ER Series - Manual (Page 17)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 16 of 52
Installation Guide
1.
Mount the pump securely to the Power Take-Off (PTO). This may require attaching
a mounting bracket to the PTO housing prior to mounting the pump.
WARNING:
Always mount the hydraulic pump in a position with the pump controls up.
Mounting the pump in any other orientation will not allow hydraulic fluid in the
pump to reach the correct level before starting, causing premature wear of the
pump, thus voiding the system’s warranty. The pump and undercarriage
components will corrode if they are left unprotected. It is advisable to paint them
before completing the installation.
2.
Locate and bore mounting holes for generator tray assembly as shown in Figure 6.
Maintain minimum clearances as indicated in Error! Reference source not found.,
Error! Reference source not found., Figure 3, and Figure 4.
OIL FILTER
ACCESS PANEL
11.64
7.25
2.06
32.00
33.50
.75
.56
4 PL.
Hole pattern for mounting ER-6.2, ER-8, ER-10and ER-110 tray assemblies
Figure 6