Smart Power Systems ER Series - Manual (Page 32)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 31 of 52
Step a: Press Mode to
cause rvn and the y and
n labels to appear.
Step b: Press On/Off to
answer “yes” and make
the next screen appear.
Example of Command & Control Center in low oil fault override
Figure 21
a. From the Normal mode display, press Mode, as if you wanted to display the oil
temperature. The screen shown in Figure 21 will be displayed instead, asking if
you want to “Run [with the] Oil Lo[w].” This screen will also be displayed if you
attempt to start the generator with the condition present.
b. Note the y and n labels below the Mode and On/Off switches. Press the On/Off
switch to answer “yes” and proceed to the next screen, or press Mode to answer
“no” and proceed to the oil temperature display.
Step c: Press On/Off to
answer “yes” and
override the shutdown.
Example of Command & Control Center
in low oil fault override confirmation
Figure 22
c. If your answer was “yes” in the previous step, the confirmation screen shown in
Figure 22 will be displayed. Again note the y and n labels below the Mode and
On/Off switches. Press the On/Off switch to answer “yes” and override the
shutdown. Press Mode to answer “no” and proceed to the oil temperature
display.
Note: If you override the system and command it to operate with insufficient
hydraulic fluid, the system output power may degrade and you will void the
system’s warranty.